Category: General discussion
Later topic: Photo/story: APA Goose & Great Northern
Earlier topic: adjust platen, makeready

Printing on Tabletop Pilot

  • lcole
  • on 5 Oct 09 (15:08)

I want to print my daughter’s wedding invitations with my Pilot.
Would I be able to print a 6 x 4 magnesium plate with art and text and get a good impression on Crane’s 110 lettra or could I get better results with a separate plate for the artwork and setting the type myself? Or am I expecting to print too large
an area with my Pilot? Any help is greatly appreciated.
Linda

Log in to reply   2 replies so far

You are right in the comfort zone for your press. I printed 5x7 invites for my sister-in-law. on my Pilot clone. If you aren’t printing a solid 4x6 rectangle, you should be just fine.

Good luck. Post your results.

  • lcole
  • on 6 Oct 09 (20:20)

Thank you for the feedback! I hope it goes well.
Linda