Heidelberg s cylinder press sheet counter adjustment

Arthur Gough
on 8 Jul 12 (12:05)

Hi,
I recently began work for a firm where I operate a Heidelberg S cylinder press for die cutting.
The sheet counter counts whether the the press is running in or out of impression. Is there an adjustment to correct this?

Thanks
Art.

Peter Luckhurst
on 8 Jul 12 (13:14)

The counter is slotted if my memory serves me correctly you just need to physically raise it a bit ,just two screws and watch out for spacers so dont pull bolts right ot just slacken enough to raise the box upward .

Peter Luckhurst
on 9 Jul 12 (05:33)

Oh another thought remember she stays in impression if the tabs are down on one half of the swing arm !

Arthur Gough
on 10 Jul 12 (17:31)

Hi Peter,
Thanks very much for your help.

Art.