Hi everyone, still working out the bugs of my new plate processor. I find that when I change the water the mounting rubber is no longer sticky. After it builds up a significant amount of washed off polymer it does stick once again. I am losing about 2 plates each cycle because of this.. Does it have a life span? What makes it sticky?
Earlier topic: V-50 cylinder will not go off impression
Plate Processor Mounting Rubber
Hi everyone, still working out the bugs of my new plate processor. I find that when I change the water the mounting rubber is no longer sticky. After it builds up a significant amount of washed off polymer it does stick once again. I am losing about 2 plates each cycle because of this.. Does it have a life span? What makes it sticky?
Log in to reply