Vandy SP-20 rollers

Coriander Reisbord
on 27 Aug 07 (14:08)

I need to get the rollers for my Vandercook SP-20 recovered, but I can’t lay hands on my manual and thus don’t have the specs for the rollers. Anybody out there know what they should be? Diameter, durometer? Or if you can point me to a site that has the information, I’d be grateful. Thanks! Cory

marty locket
on 27 Aug 07 (14:25)

Hi Cory, I’ve used Rotadyne to recover all our Vandercook rollers. They do a good job with a 2 week or so turnaround. I believe they should have specs on file for the SP-20. They have several locations in the US. http://www.rotadyne.com/new_page_117.htm. -M

natron
on 27 Aug 07 (19:42)

For an indepth look at the info on your vandercook rollers, check out the vanderblog at
vandercookpress.info

the discussion gets a bit sticky, but basically NA graphics technically owns the rights to the roller info.
NA Graphics offers roller resurfacing, as well as lots of parts and info on Vandercooks, so that may be a good option as well, but if Rotadyne is a better choice, then there you go.
Good luck!

Bielerpr
on 27 Aug 07 (19:55)

Coriander

I would recommend both RotaDyne (as previously mentioned) and Petco.

http://www.petcorolls.com/

I’ve not had problems with either and having been using them for many years.

Gerald
http://BielerPress.blogspot.com