About ericm

Recent content

Title	Updated
Kluge foil shop closing	14 Sep 22
leaving ink on windmill system	12 Jun 22
Numbering Machine repair	5 Jun 22
Locing up your die cut	12 Feb 22
Largest numbering machines	29 Jan 22
edge gilding with foil	9 May 21
Kluge "No-Name Clutch"	11 Feb 20
copper die for printing	28 Oct 19
NCIS Los Angles	15 Jun 19
mid 70's Triumph Paper Cutter switch	23 Feb 19

Recent comments

Title ↓	Date
"smashed counters" I have a standing...	27 Mar
"packing" or "make-ready" for foil is a...	13 Apr
"non-op"side? do you mean the Gear...	18 Nov
"Crown Roll Leaf" has a brochure they...	30 Sep
"Caliberation" prob consists of...	12 Feb
you've got a problem here, i would use...	8 May
you'll want to check the height of them...	19 Dec
your "makeready" is simply eliminating...	8 Oct
Your pump is not so much a pressure...	1 May
your press has a certain amount of...	12 Apr
Your pics, even tho they make sense to...	7 Apr
your going to need to find a very good...	11 Feb
Your die maker will usually etch the...	27 Jul
your best bet is would probably be to...	6 Oct
Your best bet is to contact me. There...	18 Apr
your best bet is going to an...	14 Nov
your belt size is 107 inches...	21 Jan
you wouldn't just happen to be trying...	12 Apr
You would be much better off with a...	23 Feb
You won't want to run rolls that are...	18 Mar
You won't want to run rolls that are...	18 Mar
You will prob end in the realm of 3-10;...	8 Apr
you will need to remove both flywheels...	13 Sep
you will get more out of the freon than...	23 Nov
you will be just fine with this setup...	23 Jan
you should have on the new style an arm...	20 Mar
you should be asking for test rolls for...	5 May
you should always look first at...	4 Oct
you need to watch this press Very...	25 Apr
you need to find out if the motor is...	21 Jan
you need to find out from them if they...	13 Jan
you need to find out from them if they...	13 Jan
you need to cut against a bare steel...	19 Nov
you need to be sure the press is...	18 Oct
you need quoins and furniture? you need...	9 Mar
You might want to start out with a...	2 Oct
you may think it is too big, but, once...	16 Jul
you may not be able to "tap it out"....	16 Jul
you have it upside-down it is an...	12 Jan
you have 1500+ of these little devils?	17 Apr