About casmit

image: casmit's picture
Recent content
TitleUpdated
Problems with foil floods on thin paper16 Jan 15
Windmill is creeping when clutch is in...14 Jan 15
How do you organize your foil rolls?9 Mar 14
What paper does william arthur use?9 Jan 14
Looking for foil cutter or alternatives27 Nov 13
How to cut 16 gauge copper plates?21 Nov 13
initial die placement on honeycomb2 Nov 13
problems cutting paper with heavy impression -...21 Nov 12
Adjusting windmill grippers away from platen3 Nov 12
Ink fountain not turning on windmill3 Mar 12
Recent comments
Title ↑Date
A few recommendations. Brass guides...5 Dec
a little press wash in part t0402...15 Jan
Also, it's not usually roller related....21 Nov
And my blades will last longer than a...21 Nov
any problems with setup Dick? How long...27 Jul
are you saying to remove the bolts that...9 Nov
btw...Dick, it has two good looking...27 Jul
Dick...lol. That's an awesome...4 Aug
For supplies standard ink out of PA is...22 Nov
Gentlemen I spoke to today said he knew...5 Dec
I cut a ton of business cards. The...21 Nov
I did a quick test and the tubes move...4 Aug
I didn't even realize the machine was...14 Aug
I need something for clean square cuts...21 Nov
I run 60pt stock a few times a month...11 Dec
I run the matrix on top of make ready....3 Nov
I think a couple of you have stated the...21 Nov
I think I found it. I'm looking for a...21 Nov
I think I might be low on power here....5 Nov
I was told a utility knife would melt...27 Nov
I went ahead with the Kluge purchase...27 Jul
in step #3, I was using A/B to...6 Jun
is there a preferred method besides...6 Jun
I'd also be willing to run it if you...5 Dec
I'm leaning towards the kluge, but...24 Jul
I'm needing these same rollers. If...22 Sep
I've been doing skip feeding but it's...22 Sep
I've been printing from two separate...6 Jun
James, I'd love to find someone to...15 Aug
Just an idea of what I'm working on....15 Aug
Klu Gee is how I'm pronouncing it....27 Jul
Looks like trash from the paper...21 Nov
Maybe do this as havenpress stated? See...21 Nov
my clamp is 2 inches deep I...17 Feb
my only guess on this is a rollers...27 Oct
new suckers installed and it feeds the...9 Aug
not sure what you mean by my "scale on...9 Nov
Oil based tend to be more workable at...9 Mar
ok, looks like the blade is slightly...11 Aug
pics attached.15 Aug