About Sharecropper Press

image: Sharecropper Press's picture
Recent content
TitleUpdated
1015 Kluge Auto Feed18 Oct 20
Free Ink and Paper Cutter18 Oct 20
R Hoe & Co parts24 Feb 14
C&P 1218 available in Fresno CA29 Jan 13
Parts identification needed7 Apr 10
Kluge 1015 Roller Tool22 Jan 10
Recent comments
TitleDate ↑
You might try dampened paper. I am not...26 Jan
My original controller is setup for...26 Jan
To reduce the ink I use a product...29 Jan
I've used Sterling Varnish in yellow...30 Jan
Some things to consider -- White gas...31 Jan
Is your knife sharp? A dull knife will...1 Feb
This is a common problem with small...6 Feb
I gotta' agree with Brian. The...7 Feb
Are you using really large suction cups...7 Feb
The rollers come off the ink disk with...7 Feb
Here's a link to a site with a...8 Feb
If you must do it yourself, look at...8 Feb
Devils Tail always has good advice....11 Feb
Here is a method to blind emboss with...13 Feb
I agree with Paul (Devils Tail Press)...8 Mar
Does the belt slip, or is the motor...10 Mar
Pull the other one, printmaster45!12 Mar
Dick G - Email a shipping address...8 Apr
I have a set of Adrian's rollers on my...14 Apr
Bad for your rollers! I clean my press...15 Apr
Go to this website and download the...17 Apr
Refer to the manual in my previous...18 Apr
This website (see the link below) shows...18 Apr
WALK AWAY FROM THE KEYBOARD ... this...22 Apr
Depending on your location there should...28 Apr
Hey rwarnoldjr, do you have supplier...29 Apr
You need a negative with the emulsion...19 May
here's a source for presensitized...31 May
Here is a cleanup instruction from an...17 Jun
With an imagesetter you need a film...19 Jun
The imagesetters that I am familiar...19 Jun
Lube! There're lots of places to oil...26 Jun
Where are you located? Someone in your...28 Jun
Like jhenry says, not sure about your...28 Jun
Here's a trick I use when going from...2 Jul
You might try contacting the...5 Jul
You can print okay without them. Once...12 Jul
Ultimate Numbering Machine Service...3 Sep
I made a pair out of aluminum, 1 inch...15 Sep
What press? I used leather from an old...19 Sep