KLUGE automatic

to life up the feeder arm you have to engage pin in slot, on our press I don’t think the pin lines up correctly, please check photo and tell me if this is normal alignment or should I try and line this up better
Thanks Virgil

Log in to reply   4 replies so far

sorry, image did not upload, but the pin on the disk is off by about half inch,think it should line up better, if this helps

You can get an operation manual here that should help answer your question.


Can you email or message me you pics? Your term “Pin” is a bit curious to me.

can you text me at 937-286-2475 and i will sent the pic,
I call it a pin or a post it is on the large disk on the right side of the feed arm facing the press you lift the latch up to lock in place to lift feed arm up,
thanks Virgil