About Vrooooom

image: Vrooooom's picture
Recent content
TitleUpdated
Challenge 193 Disassembly24 Jun 16
Mystic Multiples31 May 16
Kluge Feeder off the tracks7 Aug 10
Adjusting the rails on a N series Kluge?29 Jul 10
Recent comments
TitleDate ↓
Good info everyone! I'm going to move...29 Jun
Aye, making a dolly is a good idea that...24 Jun
Grainger probably carries a comparable...10 Mar
Screen printing glue is also possible...11 Dec
Not sure, but I believe Paul's info was...5 May
I can't imagine how much impression is...5 May
I don't use the press you use, but it...5 May
There was a post thread here about...27 Apr
You'd probably be fine with an airbrush...27 Apr
OK Paper may have smaller sizes, but...22 Apr
Also, I've never encountered offsetting...21 Apr
I just meant in regard to keeping your...21 Apr
The solution? Don't print! If you...20 Apr
Hi Leslie, This has been covered a...20 Apr
I'll chime in that I ordered 3 for my...17 Apr
I'd just like to point out that I...17 Apr
I believe jhenry is correct, as Studio...15 Apr
I would stick with boxcar's...14 Apr
I'd just like to point out that screen...8 Apr
Bradley Hutchinson here in Austin also...29 Mar
It's a little similar, since the...29 Mar
I'm already on the run, but the...28 Mar
I'll do it.... Otherwise, I only...28 Mar
Letterpress inks are a lot more...28 Mar
It's probably the exposure part that...25 Mar
They are still called KF152, but the...24 Mar
Oh, and my ultimate advice would be to...24 Mar
Well, printing isn't "black and white,"...24 Mar
I'm sure it depends on how metallic is...23 Mar
I'll leak out my "secret" since edge...23 Mar
You'll get better results for edge...23 Mar
In a perfect world, a quarter pound...16 Mar
Hi Jay, I just went through a...15 Mar
Yeah, I wouldn't mind finding one of...13 Mar
Some automatic Kluges have a manual air...12 Mar
I run without the feeder a lot, like...12 Mar
Etsy is a killer way to start out. Low...11 Mar
Yes, but it's nothing more than a...9 Mar
Nickelyacht, it's a pretty easy...9 Mar
Exactly. I supply a pantone number, and...9 Mar