About jason.tollefsen

Recent comments

Title	Date ↓
Geoffrey’s right: That’s most...	1 May
If I were you I'd check the amount of...	30 Apr
Depending on your press, if you've...	1 Mar
Actually... I got caught up...	1 Feb
This should help, Here's a view of...	1 Feb
Those are Bar-Plates "Adjusto...	10 Mar
Yea, the inner race might look a little...	8 Mar
I didn't see the width mentioned, but...	8 Mar
"I also tried turning the impression...	28 Jan
Hey Gunnar, I just went out and had...	23 Dec
Sure, happy to share... you should have...	14 Dec
I just re-did all the hoses on my press...	1 Nov
"I am pulling the lever as hard as I...	29 Jan
Nicely done, Your experience sounds...	19 Nov
Hey Hugo, Found that reference to an...	16 Nov
I've seen some literature somewhere...	14 Nov
Hey Ben, Follow the link in this...	6 Aug
Great find, thanks for sharing.	22 Jul
Derek, Great to hear - I was...	7 Jul
Sure - I should have mentioned that. I...	27 Jun
Hey guys - I just found...	26 Jun
Looks like you got your work cut out...	26 Jun
Jason, You mention a schematic - are...	26 Jun
Thanks Bob - Its a consequence of my...	25 Jun
Derek, I cant tell you about your...	25 Jun
Arie, Just glad to have something good...	19 Jun
Actually.... Yes, there are some C&P...	18 Jun
We just did some work using Manifesto's...	8 Jun
I'm pretty sure I've seen it mentioned...	22 Apr
I'd agree with both answers...	14 Apr
I just came across your previous post...	26 Mar
Katesy, "The further down the...	25 Mar
Thanks - yours too. I didn't have a...	12 Mar
gus+ruby, Looks like you're on the...	5 Mar
I caught on to this post a little too...	4 Mar
Aside from the occasional circumstance...	22 Dec
Matthew, I'm going through a similar...	9 Nov
Glad to help... Some more info on...	7 Aug
The set of screws up top you're talking...	6 Aug
Pammy, That’s good information...	5 Aug