About frank hemmings

image: frank hemmings's picture
  • Frank Hemmings
  • Durngate Street Press, Dorset
  • UK England
  • Member for 4 years 29 weeks.
  • Last access 3 hours 12 minutes ago.
Recent content
TitleUpdated
Funditor Saw (in the UK)5 Apr 17
aeroset dry powder anti set off spray16 Jun 16
Monotype key board and caster air supply ?7 Mar 16
Windmill lubrication question3 Aug 15
vertical miehle v50 drive belt23 Apr 15
more Vertical Meihle information sought13 Mar 15
Vertical Meihle drip tray10 Mar 15
Recent comments
TitleDate ↓
I would make a really good quality...4 Aug
It looks like a flat version of the...26 Jul
Are you using a textured stock ? Many...25 Jul
Have a look at this website...19 Jul
Hi, I have run a more modern...12 Jul
Don't forget the stock you are printing...22 May
Well done so far, the first sheet looks...13 May
I would be there like a shot, these are...9 May
Thomas, thankyou for your comment re...8 May
Not sure where you are based but...7 May
Have you checked the basic things?...7 May
Jnbirdhouse, here are the rest of the...5 May
Hi jn, will do but again it will be...27 Apr
As promised here are some pictures re...27 Apr
Hi, I have the use of a Funditor Saw...18 Apr
I have used Allmake rollers in south...1 Apr
My meihle vertical was called "Milly"...28 Mar
Generally if the bottom of the print is...24 Mar
Yes Nagraph, makeready is possibly a...24 Mar
If you have a look at the Heidelberg...20 Mar
I remember back in the late 60's when I...15 Mar
Instead of composition rollers, hsve...14 Mar
I have some metal backed polymer plates...8 Mar
Have you checked the plate under...1 Mar
Metallic printing by letterpress has...14 Feb
I have been reading all the comments...30 Jan
A Heidelberg cylinder press is the best...28 Jan
Sorry you havent had any leads on the...26 Jan
A recent recollection that might help...23 Jan
It is interesting to read the replys...14 Jan
Back in the good old days when printing...21 Dec
yes in essence you ar right. If you...20 Dec
Allmake rollers produce polyurathne...17 Dec
I have used allmake rollers and they...10 Dec
As a windmill user can you tell me or...5 Dec
Looking at your photos I wondered if...23 Nov
Hi Western 411, Assume you are...22 Nov
Hi If you are sure the rollers are set...4 Nov
Sorry did not not explain myself very...23 Aug
One of the major things to consider if...22 Aug