About Arie Koelewyn

image: Arie Koelewyn's picture
Recent content
TitleUpdated
Hammond Glider motor12 May 17
Old Ink30 Jul 14
Johnson Type Foundry Philadelphia24 Jan 13
The Paper Airplane Press21 Oct 10
National Amateur Press Association21 Nov 06
Recent comments
TitleDate ↑
Not much room in a 5x8 chase for...12 Mar
I've never seen any parts list for the...18 Mar
Yes. Especially if you have a really...18 Mar
Check out the Letpress archives....19 Jun
You might start by saying where you...20 Jun
Go to David Rose's web site and buy one...23 Jun
This is a New Series C&P (After 1911 or...9 Jul
Lorie: There would have been one for...11 Jul
Why not find a press in Australia? The...11 Jul
Try some roller bearers outside the...20 Jul
Owosso Graphic Arts does copper cuts....1 Aug
Alan: Would you be willing to post a...2 Aug
You may want to get it air...7 Aug
If you're referring to the ones in...12 Aug
I've used a dremel successfully. Not...12 Aug
The late John Bright, who owned Sigwalt...11 Sep
Try turning the part that attaches to...21 Sep
Yes. I use roller bearers all the...2 Oct
How large is the plate in comparison to...10 Oct
Courtney: Start here....16 Oct
By brace, do you mean the Rocker Lock...16 Oct
Not quite all of them. Just the APA...17 Oct
Look at:...17 Oct
Is the Rocker Spring broken? or the...17 Oct
Hmmm. The only thing I can think of...18 Oct
Kinda far away from Michigan. Look for...19 Oct
Bill: Yes the stud comes out through...21 Oct
I've done it a number of times. It's...26 Oct
Owosso Graphic Arts will happily make...11 Nov
Rent a U-haul trailer instead. There's...14 Nov
The one in my garage is ~44" wide....18 Nov
What jgbeaumont is calling the platen...19 Nov
Sounds like you'll have to adjust the...19 Nov
If the press is not on skids, you may...20 Nov
Rubber is usually black and composition...20 Nov
Turn it on a while before you want to...20 Nov
If the truck you are using to go...22 Nov
Even simpler, simply place the pallet...25 Nov
Yes. C&P's are top-heavy. They can be...26 Nov
I use a bone folder and then trim on...26 Nov