About sylvia c

image: sylvia c's picture
Recent content
Windmill Roller Problem3 Jul 19
Any tips for more vibrant colors on small type?25 Apr 19
Photopolymer Plate Longevity8 Mar 18
Windmill pump making unusual noise7 Dec 17
Dave Robison (Ink in Tubes)26 Mar 16
No. of parts for Pantone Warm Grey 9 ?21 Jan 16
Windmill diecutting, paper scraps22 Aug 15
Windmill weekly lubrication question1 Aug 15
Windmill Paper Guide for Small Sheets (bus. cards)24 Mar 15
Windmill Rider Roller30 Oct 13
Recent comments
Title ↑Date
A very good source...12 Apr
As I said, I've had very good...30 Mar
Daniel, Do you happen to have a link...15 Dec
Daniel, Yes it's an SP-15. It doesn't...15 Dec
gachap, could you post the address of...7 Oct
HavenPress, I use both Van Son & Ink...27 Apr
Hi Frank, Thanks for your response....26 Apr
Hi Frank, Yes I can match a small...25 Apr
Hi J Russell & Colophon, I do use a...26 Apr
I am new to die cutting. I do think my...24 Aug
I am so concerned to hear this news...16 Jul
I do have the manual, I'll take a look....15 Dec
I recently had a problem where inking...15 Mar
It's difficult to imagine that in 8...27 Mar
I'm fairly certain they are the same...5 Jul
jhenry, Before putting the bearings and...7 Jul
Just wanted to come back and say that I...10 Feb
kellypress, Thanks, this sounds like a...22 Aug
letterpress standard, I will check the...9 Jul
Matt, The space is approx. 12 x 12...23 Jul
mick, thanks for all your comments. I...6 Jul
No I'm not running without the bearing...4 Jul
Thank you all for your comments on this...14 May
Thank you gachap & foothillpress for...7 Sep
Thank you very much Geoffrey-- I was...21 Jan
Thank you very much for the comments. I...30 Oct
Thank you! I'm aware of some of these...9 Aug
Thanks for the advice everyone. I've...2 Aug
Thanks HavenPress this is really...26 Apr
Thanks Pete, I will email you.31 Mar
Thanks, I will investigate.9 Dec
To be more specific, they are referred...24 Mar
Yes I have a studio space built into...23 Jul