About casmit

image: casmit's picture
Recent content
TitleUpdated
Problems with foil floods on thin paper16 Jan 15
Windmill is creeping when clutch is in...14 Jan 15
How do you organize your foil rolls?9 Mar 14
What paper does william arthur use?9 Jan 14
Looking for foil cutter or alternatives27 Nov 13
How to cut 16 gauge copper plates?21 Nov 13
initial die placement on honeycomb2 Nov 13
problems cutting paper with heavy impression -...21 Nov 12
Adjusting windmill grippers away from platen3 Nov 12
Ink fountain not turning on windmill3 Mar 12
Recent comments
TitleDate ↓
Thanks for all the feedback on this....19 Jan
a little press wash in part t0402...15 Jan
Oil based tend to be more workable at...9 Mar
pricing is hugely dependent on the...9 Jan
what's the serial number?9 Jan
I run 60pt stock a few times a month...11 Dec
I'd also be willing to run it if you...5 Dec
A few recommendations. Brass guides...5 Dec
Gentlemen I spoke to today said he knew...5 Dec
Sounds good Carl. I'll call later...1 Dec
I was told a utility knife would melt...27 Nov
To clarify, this is to cut hot foil...27 Nov
For supplies standard ink out of PA is...22 Nov
I need something for clean square cuts...21 Nov
I think I found it. I'm looking for a...21 Nov
Thats an idea. Never tried rotating...23 Nov
Also, it's not usually roller related....21 Nov
Looks like trash from the paper...21 Nov
Maybe do this as havenpress stated? See...21 Nov
And my blades will last longer than a...21 Nov
I think a couple of you have stated the...21 Nov
we drop-off/pickup blades every...21 Nov
I cut a ton of business cards. The...21 Nov
I run the matrix on top of make ready....3 Nov
Thx for the detailed response Peter....4 Mar
Yes. Turns with hand wheel fine. 4 Mar
are you saying to remove the bolts that...9 Nov
not sure what you mean by my "scale on...9 Nov
Thanks for the all the input! I think...21 Aug
right on. pins leave marks on the...19 Aug
pics attached.15 Aug
so when running sheetwise, you maintain...7 Jun
I've been printing from two separate...6 Jun
is there a preferred method besides...6 Jun
Yes, with guides.6 Jun
in step #3, I was using A/B to...6 Jun
so no electronic notifications, etc. to...1 Mar
my clamp is 2 inches deep I...17 Feb
Thanks! The one side is perfectly cut...19 Nov
I think I might be low on power here....5 Nov